GTR suspension on GTS - GT-R Register - Official Nissan Skyline and GTR Owners Club forum

Mikster · 9th October 2008, 07:31 PM

Hello

I want to fit new GTR circuit suspension on my R33 GTS track car. So far I have gathered that I will need GTR rear hubs to allow this - anyone know if I will need GTR driveshafts too or other parts?

Cheers

Mike

Simonh · 11th October 2008, 04:41 PM

I think you will just need the rear hubs, if you are not changing the track width then the driveshafts will be fine I think

Simon

Chris Wilson · 16th October 2008, 03:31 PM

I have done this conversion to my own GTS-t. It was 2 years ago, so memory is hazy, but you DO need the GTS-t hub bearings in the GTR alloy hub carriers. You also need to mod or remove the inner dust shields. You use the GTS-t shafts. It was fairly straightforward.

9th October 2008, 07:31 PM	#1 (permalink)
Mikster GTR Register Member Join Date: Feb 2006 Posts: 92	GTR suspension on GTS Hello I want to fit new GTR circuit suspension on my R33 GTS track car. So far I have gathered that I will need GTR rear hubs to allow this - anyone know if I will need GTR driveshafts too or other parts? Cheers Mike

11th October 2008, 04:41 PM	#2 (permalink)
Simonh GTROC Member Join Date: May 2002 Location: Nottingham Posts: 2,988	I think you will just need the rear hubs, if you are not changing the track width then the driveshafts will be fine I think Simon __________________ Composite Design Studio webpage Doing it is not enough - it has to be done right. My Auto Journal

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

16th October 2008, 03:31 PM	#3 (permalink)
Chris Wilson GTR Register Member Join Date: Aug 2001 Location: Shropshire Posts: 1,487	I have done this conversion to my own GTS-t. It was 2 years ago, so memory is hazy, but you DO need the GTS-t hub bearings in the GTR alloy hub carriers. You also need to mod or remove the inner dust shields. You use the GTS-t shafts. It was fairly straightforward.