[sideways.taff]

...cont

Some A-pillar gussets were welded in and rear firewall fabricated and installed.


Remote fluid reservoirs were mounted onto the bulkhead.


A custom centre console plug was made to enable the switch gear to be mounted nearer to the driver seat as the dash was now too far away to be reached when the driver is fully belted in.


Panel templates were made prior to fabrication of custom aluminium panels.


Out on the drive for the first time, badass!







The SR20DET goes back together for engine bay mockup.



Custom centre console prototype test fitted, a bulge was incorporate to gain clearance over the top of the diagonally mounted hydraulic handbrake. The flat section at the rear will be where the switch gear is mounted.



Aluminium, boot mounted, fuel tank


Fuel pump and swirl pot mockup and panel templates were put in place.


The fuel pump mounting plate was welded in



cont...