GT-R Register - Official Nissan Skyline and GTR Owners Club forum - View Single Post

andy42uk · 27th March 2007, 09:23 PM

I KNOW this is different, but relevant I hope.
I have just had my RB25DET block bored to suit 87mm Wiseco pistons, 3 thou was the suggested clearance, when I put the block in I was advised by the machinist that slightly under will be fine, he highly rated wiseco's since they were brought out around 2000, He did my last re-bore about 16 months ago, (different car and engine) it was good.....I crashed it!
I'll let you know, I pick it up tomorrow and by Sunday I'll have the lot done and be driving...
Regards,
Andy.

27th March 2007, 09:23 PM	#333 (permalink)
andy42uk GTR Register Member Join Date: Sep 2005 Location: Oxford Posts: 860	I KNOW this is different, but relevant I hope. I have just had my RB25DET block bored to suit 87mm Wiseco pistons, 3 thou was the suggested clearance, when I put the block in I was advised by the machinist that slightly under will be fine, he highly rated wiseco's since they were brought out around 2000, He did my last re-bore about 16 months ago, (different car and engine) it was good.....I crashed it! I'll let you know, I pick it up tomorrow and by Sunday I'll have the lot done and be driving... Regards, Andy.