TACHO install help - GT-R Register - Official Nissan Skyline and GTR Owners Club forum

NissanStyle · 26th December 2006, 05:23 AM

Can someone tell me which wire to splice to connect the autometer monster tacho, Live, earth illumination is sorted. just the pick up, i knoe it goes to the coil but which colour wire?????

NissanStyle · 26th December 2006, 05:54 AM

ANYONE?

Stony · 1st July 2008, 02:28 AM

WHOA bringing this back from the dead!!!!

Same question but im using a standalone version of vPro. I tapped into the little loop in the connector just before the ignitor but not getting anything. correct wires are snipped and electrically the gage is working just not getting an RPM.

fuelburner · 1st July 2008, 04:53 AM

Could you not hook it up to pin 7 on the ecu (tacho engine rev signal), that's on an rb26dett ecu by the way.

Stony · 1st July 2008, 05:24 AM

Trying to verify that the Vpro ECU is the same as the stock ECU. pretty sure its not since you need an adapter harness that goes between the engine harness and vpro ECU

26th December 2006, 05:23 AM	#1 (permalink)
NissanStyle Banned Join Date: Feb 2006 Location: Hopefully Japan Posts: 174	TACHO install help Can someone tell me which wire to splice to connect the autometer monster tacho, Live, earth illumination is sorted. just the pick up, i knoe it goes to the coil but which colour wire?????

1st July 2008, 04:53 AM	#4 (permalink)
fuelburner GTROC Member Join Date: Oct 2006 Location: Middle Earth Posts: 1,015	Could you not hook it up to pin 7 on the ecu (tacho engine rev signal), that's on an rb26dett ecu by the way. __________________ 燃料バーナー

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

26th December 2006, 05:54 AM	#2 (permalink)
NissanStyle Banned Join Date: Feb 2006 Location: Hopefully Japan Posts: 174	ANYONE?

1st July 2008, 02:28 AM	#3 (permalink)
Stony GTR Register Member Join Date: Sep 2007 Posts: 64	WHOA bringing this back from the dead!!!! Same question but im using a standalone version of vPro. I tapped into the little loop in the connector just before the ignitor but not getting anything. correct wires are snipped and electrically the gage is working just not getting an RPM.

1st July 2008, 05:24 AM	#5 (permalink)
Stony GTR Register Member Join Date: Sep 2007 Posts: 64	Trying to verify that the Vpro ECU is the same as the stock ECU. pretty sure its not since you need an adapter harness that goes between the engine harness and vpro ECU