GT-R Register - Nissan Skyline and GT-R Drivers Club forum - Search Results

Want to buy a banner ad? Find out more here.

Go Back   GT-R Register - Nissan Skyline and GT-R Drivers Club forum > Search Forums
Register Garage FAQ Members List Calendar Search Today's Posts Mark Forums Read Insurance


Showing results 1 to 25 of 481
Search took 0.07 seconds.
Search: Posts Made By: ACspeedtech
Forum: General Nissan R35 GT-R Chat 24th September 2019, 08:09 PM
Replies: 4
Views: 347
Posted By ACspeedtech
A firm recommendation for Prospray from us, they...

A firm recommendation for Prospray from us, they do all our bodyshop work and always provide top service and a perfect job. Anything from a few scratches to a full repanel front to rear of a GTR so...
Forum: General Nissan R35 GT-R Chat 16th August 2019, 08:31 AM
Replies: 14
Views: 344
Posted By ACspeedtech
You need a ProEcu programming kit or a Bluetooth...

You need a ProEcu programming kit or a Bluetooth kit PLUS a usb dongle. The key part being the usb dongle which has the protocols to allow programming via Ecutek :)
Forum: General Nissan R35 GT-R Chat 15th August 2019, 06:58 PM
Replies: 7
Views: 323
Posted By ACspeedtech
The oem ecu uses the MAFs as the primary load...

The oem ecu uses the MAFs as the primary load reference, dumping air out the system means the load calcs are off and the clutch control/fuelling/ignition timing goes seriously off, especially if the...
Forum: General Nissan R35 GT-R Chat 15th August 2019, 06:51 PM
Replies: 14
Views: 344
Posted By ACspeedtech
At that level of tune a remote tune would be...

At that level of tune a remote tune would be easily done, if anything is a little awry (i.e. poor intake design so a very non-linear maf curve) then a simple swap to SD would also cater for it....
Forum: General Nissan R35 GT-R Chat 15th August 2019, 06:47 PM
Replies: 24
Views: 532
Posted By ACspeedtech
Unfortunately not, they're a single piece item. I...

Unfortunately not, they're a single piece item. I would say there may be a way (like the Porsche ones) to remove the stock ball joint, insert a collar and fit an aftermarket one... But as yet not...
Forum: General Nissan R35 GT-R Chat 14th August 2019, 02:27 PM
Replies: 24
Views: 532
Posted By ACspeedtech
Cheers Nick, will reply to that. ...Agree...

Cheers Nick, will reply to that.

...Agree that you should check the ball joints, we've changed a fair few of those, normally though if the car has been kerbed badly or had an 'incident' :) they...
Forum: General Nissan R35 GT-R Chat 13th August 2019, 09:27 AM
Replies: 24
Views: 532
Posted By ACspeedtech
Really common issue to have the rear bushes fail....

Really common issue to have the rear bushes fail. Changing to aftermarket ones is a massive improvement in not only the geometry when taking advantage of the extra caster addition/anti dive but also...
Forum: General Nissan R35 GT-R Chat 28th July 2019, 05:30 PM
Replies: 6
Views: 270
Posted By ACspeedtech
Thanks Adrian, we have both domains, but these...

Thanks Adrian, we have both domains, but these days use [email protected] as the main one.
The website is under construction... Just need a little more time to finish a few bits off!
Forum: General Nissan R35 GT-R Chat 28th July 2019, 02:38 PM
Replies: 6
Views: 270
Posted By ACspeedtech
Apologies if people can't get through on the...

Apologies if people can't get through on the phone all the time, there's only a few of us and the phone rings on average every 12 minutes!
We sort all the office related things out first thing...
Forum: General Nissan R35 GT-R Chat 17th June 2019, 06:33 PM
Replies: 22
Views: 616
Posted By ACspeedtech
That's our neck of the woods, we use Prospray...

That's our neck of the woods, we use Prospray (Warrington/Lymm area) and they've carried out many major repairs and full resprays for us, other customers (e.g. Kyle) have also used them and been...
Forum: Latest Products, Offers and News from our Sponsors 20th March 2019, 02:10 PM
Replies: 6
Views: 825
Posted By ACspeedtech
I think with a few pointers (and maybe a...

I think with a few pointers (and maybe a suspension upgrade!) you'll be a lot faster! Having confidence in the hard braking ability over the DS2500s will mentally make a big difference too.
Forum: Latest Products, Offers and News from our Sponsors 18th March 2019, 10:41 PM
Replies: 6
Views: 825
Posted By ACspeedtech
New! Motek racing brake pads!

ACspeedtech are happy to announce distributorship of and to offer a new to Europe option for performance brake pads. Welcome to MOTEK RACING here in the UK and Europe!

249715

MOTEK RACING have...
Forum: General Nissan R35 GT-R Chat 9th March 2019, 10:14 AM
Replies: 21
Views: 956
Posted By ACspeedtech
The GTR is very target based so even if the map...

The GTR is very target based so even if the map was off it should compensate to a fairly large amount. Possible wrong map loaded (mapped for intakes) or possible lambda sensor fault dropping the car...
Forum: General Nissan R35 GT-R Chat 4th March 2019, 01:04 PM
Replies: 24
Views: 949
Posted By ACspeedtech
Make sure you do an ECU reset even if it shows no...

Make sure you do an ECU reset even if it shows no codes.
If you've (for instance) unplugged a pre throttle sensor or have a fault with the solenoid, they disable the boost system and run wastegate...
Forum: General Nissan R35 GT-R Chat 11th January 2019, 08:41 PM
Replies: 4
Views: 479
Posted By ACspeedtech
The grinding/groaning may be a bellhousing issue,...

The grinding/groaning may be a bellhousing issue, or you're hearing the clutch plates semi engaging ready to drive (i.e. when you select drive/rev) by running -4 touchpoint on the odd gears, the...
Forum: Technical Chat 19th September 2018, 09:37 PM
Replies: 38
Views: 1,445
Posted By ACspeedtech
No problem, we've had sillier moments! ...the...

No problem, we've had sillier moments!
...the code is for a shift fork... but could be one of about 8 things causing said shift fork not to be where it's supposed to be. Could be a simple fix! ...or...
Forum: Technical Chat 19th September 2018, 08:09 PM
Replies: 38
Views: 1,445
Posted By ACspeedtech
If there's a flashing transmission light then...

If there's a flashing transmission light then there will be a code stored, are you reading the TCU? or just the ECU?
At that mileage there's a few wear and tear related issues we commonly see....
Forum: Technical Chat 19th September 2018, 07:09 PM
Replies: 38
Views: 1,445
Posted By ACspeedtech
Those are all engine fault codes, not...

Those are all engine fault codes, not transmission, I'd clear those out and keep an eye on them though, maybe just a low voltage at some point, but would certainly monitor.

Have you got any...
Forum: General Nissan R35 GT-R Chat 12th September 2018, 01:54 PM
Replies: 34
Views: 2,434
Posted By ACspeedtech
Engine oils.. Depends which one, I've had some...

Engine oils.. Depends which one, I've had some eye opening lab tests on some tbh, however the 300v is very good. I believe their DCT fluid is actually a Fuchs one rebranded.
Forum: Technical Chat 12th September 2018, 09:12 AM
Replies: 38
Views: 1,445
Posted By ACspeedtech
Without a little more info from a code read it's...

Without a little more info from a code read it's quite difficult to say, it literally could be a 'glitch' though! ...these transmissions are known to occasionally have a little moment which can throw...
Forum: General Nissan R35 GT-R Chat 11th September 2018, 09:38 PM
Replies: 34
Views: 2,434
Posted By ACspeedtech
Millers Oils DCT fluid. Identical spectrograph to...

Millers Oils DCT fluid. Identical spectrograph to the Pentosin but double the additive content and much more sensibly priced. Always in stock. :)

The pentosin ffl-r is very good at high temps, but...
Forum: General Nissan R35 GT-R Chat 11th September 2018, 10:37 AM
Replies: 28
Views: 648
Posted By ACspeedtech
Any change is ride height will massively change...

Any change is ride height will massively change the geo settings and corner weighting. For a road car be aware that if you lower it more than 18mm you'll struggle to get the camber under 2 degrees...
Forum: General Nissan R35 GT-R Chat 6th September 2018, 09:27 PM
Replies: 13
Views: 545
Posted By ACspeedtech
Ignoring occasional dragging (Friday nights...

Ignoring occasional dragging (Friday nights aside, each to their own especially if a little floral number is involved) then at that torque level I'd probably go for billet clutch baskets, clutch...
Forum: General Nissan R35 GT-R Chat 6th September 2018, 08:46 PM
Replies: 13
Views: 545
Posted By ACspeedtech
A 'fully built box' could go from 7k to 24k...

A 'fully built box' could go from 7k to 24k depending what level you need, from 'I dont want to wipe 4th gear off on track' to 'i want to drag launch 1000ftlb on my already 70,000 mile old trans'
...
Forum: Latest Products, Offers and News from our Sponsors 6th September 2018, 08:35 PM
Replies: 18
Views: 4,516
Posted By ACspeedtech
Hugh, apologies for late reply, been on a 4 week...

Hugh, apologies for late reply, been on a 4 week BT merry-go-round without permanent net access!

Ok, so the stock cradle has steel supports for the bearings but the rest is cast, there seems to be...
Showing results 1 to 25 of 481

 
Forum Jump

All times are GMT. The time now is 01:19 AM.


Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
http://www.Tyreforums.com

tyreforums

 

Garage Plus vBulletin Plugins by Drive Thru Online, Inc.