GTR Forum banner
1 - 11 of 11 Posts

·
Registered
Joined
·
662 Posts
Which inevitably leads to the next question which is the best :D

OK on a more serious note, Dino, where did you hear of the Wilwood kit? There is an R32 GT-R here with Wilwood Calipers, however, as far as I know, they are mounted on custom brackets..??

Do you know if they make a kit? I have good experience with them in the US.
 

·
Registered
Joined
·
9,546 Posts
I've know of Willwood for quite some time. They make 340mm & 355mm rotors combined with 6 pot calipers for R32/33/34s. They are sold here in Japan through Pool Getti which I think takes care of the brackets and general fitting .... they were also featured in GTR Magazine a few times.
 

·
Registered
Joined
·
1,724 Posts
Discussion Starter · #11 ·
Hi Spec

Should have know that one Eh Tigger..... :D

Any body have the hispec brake conversion, if so what are they like.... I had a set on my Pulsar ( there are still on the GTiR) andthought they were very good, although I have heard some bad things about other GTiR conversions... wondered if it was the same on the GTR...:confused:
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top