[markpriorgts-t]

Ok polishing all my engine bay and would like to do the crank angle sensor, if the wheel inside the angle sensor turns while off the car will this cause any problems?

 

[Marky_GTSt]

It has to be put back on in exactly the right place, Its been a while but doesnt it fit only one way ?

P.S. It either wont run or will run badly if its put back on wrong.

 

[markpriorgts-t]

it will only go on one way but at the back of it there is a little spinning cog inside a shaft

 

[Marky_GTSt]

But doesnt that also only fit one way ? If not its going to be tricky...

 

[markpriorgts-t]

ahhh ha your right it has a small groove at the bottom of the shaft aswell as the teeth at the top thanks :bowdown1:

 

[Marky_GTSt]

Isnt it a bit early for polishing engine bits ?