[D-Ranged]

I have an EGT sensor to go in my downpipe but dont know how to run the cable into the cabin. It has a two prong connector on the end. The only place i can see that runs close to the ecu inside the car is on the firewall behind the ABS sensor but i tried pushing a bit of metal wire through there but couldn't get it through and was worrying i would pierce one of the wires on the ECU loom...

Are there any other ways to get it into the car?

Car is an R33 GTR

 

[R32 Combat]

You could try the A/C bulkhead grommets?

 

[D-Ranged]

You could try the A/C bulkhead grommets?

Good idea! I don't have a/c anymore either. Will give it a try, thank.

 

[D-Ranged]

I ran it through the drivers side in the end couldn't get anything through the a/c grommet

 

[majestic]

Good to see you getting on with car Alex

 

[D-Ranged]

Good to see you getting on with car Alex

Its pretty much done now mate!

Just need to solder in the wideband and EGR sensors and that's that. Car is booked in at fabricators to get v-band flanges welded on the 4th. Just having issues with the map at the moment because i cant seem to get the car started on the base map that comes with the Link G4 and the one that was on that car will get the car started it but it doesnt like it at all.