GTR Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
187 Posts
Discussion Starter · #1 ·
Hello

I wanted to ask if the GTR engines / ECU / Wiring looms are interchangeable?

I'm putting a RB26DETT into my R34 and ideally want to use R34 GTR clocks so i wondered if say.. an R34 GTR Loom and ECU would work with a 33/32 GTR engine..

Forgive me if its a stupid question, but being as rare as R34 GTR engines are.. its most probably going to be a 32 or 33 Rb26 that goes into my car, so just wanted to some insight..

Thanks
 

·
Registered
ER34 GTT
Joined
·
306 Posts
R34 GT-R harness is a bad idea as it uses immo and coils with igniters. It's easier to connect R32/33 harness with R34 NEO harness. That's what I did in my car.
ECUs from R32 and R33 are interchangeable but oxygen sensors are different and must be replaced.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top