[Sub Boy]

Yes to the pull clutch

R33 Boxes (and the late R32 boxes which are the same) have two vents on the bell housing

 

[Sub Boy]

thats a 33gtr box adapted to fit a 32, you can tel they have drilled the castings and threaded them.

X2

 

[Sub Boy]

So I could change my push type to pull type just by changing the bell housing? ie buying a late r32/r33 bell housing? this is because I found a "cheap" tripple plate clutch that is pull type.

Not the bell housing, The front plate that the clutch lever pivots on.

 

[Sub Boy]

oooh! ok, but where on the bell housing would you place the slave cylinder now? (sorry to hijack the thread hehe its about the same issue) So..
Things to buy in order to perform this push to pull conversion are:
Front plate that the clutch lever pivots on.
lever
any other?
will the spline that goes through the clutch fit the pull type clutch(exedy tripple) since its a early 32 spline?

cheers,
joe

:chairshot
The third picture down shows both the push and pull mounting holes, with the clutch fork boot in the middle. You will have to take the clutch slave cylinder/fork/centre plate/clutch from the previous box, and install it into the new one.:clap: