GTR Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
752 Posts
So I could change my push type to pull type just by changing the bell housing? ie buying a late r32/r33 bell housing? this is because I found a "cheap" tripple plate clutch that is pull type.
 

·
Registered
Joined
·
752 Posts
oooh! ok, but where on the bell housing would you place the slave cylinder now? (sorry to hijack the thread hehe its about the same issue) So..
Things to buy in order to perform this push to pull conversion are:
Front plate that the clutch lever pivots on.
lever
any other?
will the spline that goes through the clutch fit the pull type clutch(exedy tripple) since its a early 32 spline?

cheers,
joe
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top