GTR Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,883 Posts
Discussion Starter · #1 ·
Hi

I am about to install Power FC PRO in my car. Before i take out the stock ECU, what should the ignition timing be??
Should it be set at 0 degrees? so that the number displayed in the table is the actual timing.

Currently i am running it 15degrees, with ron98 fuel.

Asim...
 

·
Registered
Joined
·
1,883 Posts
Discussion Starter · #3 · (Edited)
ExScoobyT said:
Fit the PFC, timing off No1 cylinder should be 20Deg hot.
Ok... but then i would have to ad 20 degrees to the number in the adjustment table???

0 degrees in adjustment table = 20degrees at the engine ???

Wouldn't it be easier to just set the cas to 0degrees, and then the number displayed in the table is the actual ignition timing??
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top