GTR Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,436 Posts
Discussion Starter #1
Guy's I have a Nismo Twin plate clutch to fit to my RB30 and I don't have an alignment tool to fit it? I have not used a twin plate before but would I be correct in thinking I need a special splined tool or dummy gearbox shaft to make sure the splines in both plates line up?
Does anyone know where I can get such a tool or dummy shaft or does someone have one I can borrow please?

Thank you
Lee
 

·
Premium Member
Joined
·
180 Posts
From memory the splines on the plates slide onto a central boss, you just have to make sure the boss is central when tightening up the pressure plate. I think I did this by eye!!

p.s. mine was the super coppermix, don't know if they are different.
 

·
Registered
Joined
·
1,436 Posts
Discussion Starter #4
good Spot Andy! Does the prop have an end that will locate in the crank nose as well to centralise the plates?
Thanks again.
Lee
 
1 - 4 of 4 Posts
Top