GTR Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
98 Posts
Discussion Starter #1
Anyone have experience or a good guide to converting a late R32/R33 pull type clutch over to a push type? Is it worth it? I picked up a brand new Tilton Triple Plate that's a push type, and need to figure out if converting to push is the better course of action than to pick up a pull type clutch and sell the Tilton. Thanks!
 

·
Registered
Joined
·
4,586 Posts
The easiest way to do it on an R32/R33 GTR 5 speed it to find a backing plate,clutch fork and slave cylinder from an early R32 GTR gearbox. It all bolts straight up, but you may need to drill and tap the two mounting bosses for the push slave cylinder.
The question if they are any better is hard to say, some say the push is better, but the way the pull is built it is a better design......who knows.
 
1 - 2 of 2 Posts
Top