GTR Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
9,751 Posts
Discussion Starter · #1 ·
I have seen a crank with wear of 0.010 across both big end and main ends. With this wear am I still with in spec for std size bearings?
 

·
Skyline Section Manager
Joined
·
11,878 Posts
Not according to Nissans spec. Who's bearings are you looking to use?
 

·
Skyline Section Manager
Joined
·
11,878 Posts
You do not have a choice with ACL bearing. Buy a set and plastigauge them. You should be in spec. Nissan journals have over 10 microns of size difference. Depends on the actual size. Have you measured them?
 
1 - 7 of 7 Posts
Top