[Richard Bell]

HI Guys,

I`v got the machine but no specs for the R33 GTR !! Does any one know what the factory toe in/out,camber/caster angles are ment to be !!!

Long shot I know

Richard

 

[woosh & go]

toe in/ out

Should be set to parrallel.

Rgds Ian W

 

[Peter]

Thought it was 1mm toe in....?

 

[DCD]

From GT-R Magazine:

Front:

Camber: -0.50deg (+/- .45)
Caster: 3.55deg (+/- .45)
Toe in: in 2~0 mm

Rear:

Camber: -1.05deg (+/- .45)
Toe in: in 0~5.2 mm

 

[Chilli]

A post from the past revival!

Not being the mech minded type - i have just had 265 40 17's put on all corners & took it today to a garage for a 4 wheel laser alignment.

they asked me for the settings as they could set it up but didn't have them themselves?

do i just give them the figures from the above post- camber, toe in etc for front & rear?


are these the correct settings or will they only suit standard alloys/tyres etc?

it's a 33gtr

thanks for any help :thumbsup:

 

[ru']

Settings should imho be the same for you:

http://www.risingsunperformance.co.uk/shop/pdffiles/geomspecs/BCNR33GTR.pdf

 

[glenn gtr]

settings for the r33 gtr are plus 1 fronts to 0 tollerance and plus half on the back r33 gtst plus 1 front parralel on back i work for tyre fitters had to find these through autodata so i know they are right.

 

[Chilli]

:thumbsup:

 

[Chilli]

Jeez!! - roll on friday now I have the settings thanku Ru & the gtr booked in for 4 wheel laser alignment.

It handles & drives badly now the new Toyo's are on & not set up

stuck my head under the car earlier after about 50 (gentle) miles of road use to inspect the tyres & the inner tread has just started to scrub :runaway:

gonna use the daily motor until friday

 

[ru']

Universal imho