[D-Ranged]

I have taken the top and bottom lids off and now underneath the ecu there is about 6 (3 each side) silver nipple looking things which look like they may have screws underneath them but they are glued on. I tried pulling one off but didnt want to damage the ECU.

How do you remove the R33 GTR ECU from the case?

 

[D-Ranged]

Nobody know how to do this?

 

[[email protected] M/S]

Do you mean the screws that hold the heat sinks?

 

[D-Ranged]

Do you mean the screws that hold the heat sinks?

No there is 3 screws at the bottom that are covered in solder. I tried heating it up with my soldering iron but could only get the surface hot enough. Will have to try it at work there are much better ones there.

 

[[email protected] M/S]

Hi, I will have a look and get back to you.

thanks


Mark

 

[D-Ranged]

For anyone facing the same issue, I managed to remove it by using a gas soldering iron which has a blowtorch bit with it. I turned the soldering iron up full blast and put the end against the side of the solder then got a screw driver and stuck it through the solder and removed it quickly before the solder dried and got the screw stuck. Repeat for the other 5.