GTR Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
378 Posts
Discussion Starter #1
Hi guys whats a good safe setup for around 500bhp, from what iv been reading these engines are good for 500 on standard internals so just after a bit of advice plz :)
The engines going into a s14a for drifting :D and its from a gtr32..

so far i have:

hks twin filters
blitz intercooler
trust downpipe
decat

think i`ll go the single route for a bit of ease and space to work on, maybe a tdo6 or similar for uick spooling and good power, but open to other options.. also not to sue on the fueling side but id like to run a power fc and commander for the ecu

cheers
 

·
Registered
Joined
·
378 Posts
Discussion Starter #3
i didnt think it would take much to get me there lol, would the 700 injectors fit the standard fuel rail?
the engines about done apart from the loom fitting so going to give it a few week running it then start tuning :D
 

·
Registered
Joined
·
8,804 Posts
Yes, they'll fit the standard rail. You will want to change the fuel pump as well, and you'll want some decent boost control. Doing intakes is probably unnessasary; they give about 15hp but then you deal with cold air problems, as in not getting any.

You may start running into clutch issues as well as you up the power.
 
1 - 4 of 4 Posts
Top