Anyone know the length (in cm or inch is also fine) from the bellhouse flange to the front of the main pulley? I have limited space in the vehicle I'm putting the engine in. I was originally planning on putting an I6 2jz-gte in this car, but just found out the steering rack is completely in the way of the engine, limiting my engine bay by A LOT. So the only engine I can fit in this car will be a V6. Honda NSX, 3000GT, 370Z and GTR come to my mind now....
ok guys, for everyone doing engine swaps or considering one with the new skyline engine, here are some measurements to see if it clears your supra, 300zx, 350z, fiat panda or whatever engine bay!
Thread revival alert! I am looking to do an engine swap for a vr38 dett into a project car... but I need to check if it will fit, as its a mid engine setup. Would anyone be so kind to revive these now defunct photobucket images or post up some engine dimensions, 'bellhouse flange to the front of the main pulley ' and also width measurement and height from bottom of the sump to highest point?
many thanks
Nobody has these diagrams? Would be great to get some dimensions for christmas! cheers
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
GTR Forum
2.4M posts
69.2K members
Since 2001
A forum community dedicated to Nissan Skyline GTR owners and enthusiasts. Come join the discussion about performance, mods, troubleshooting, body kits, classifieds, maintenance, and more!