GTR Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
183 Posts
Discussion Starter · #1 ·
Finally got my engine out and split to find that the cylinder bores are badly scored and may need a rebore meaning bigger pistons and lots of money .
I'm hoping to get a bare rb26 block with standard bore size as I reckon this is the cheaper option (I'm totally skint from paying for the car and then all the rebuild costs in the last 4 months!!!!).
Anyone who has one please pm or email me ([email protected]).

Cheers,
Jonny

PS also looking for a o/s/f driveshaft (that's the driver's front one btw ).
 

·
Registered
Joined
·
183 Posts
Discussion Starter · #4 ·
Mr Maj,
please contact me urgently! You have sent the wrong driveshaft and I cannot complete my rebuild until I recieve the correct one!

Jonny
 

·
Registered
Joined
·
183 Posts
Discussion Starter · #5 ·
Ok Mr Maj doesn't have the osf driveshaft I need so I'm back on the lookout for one URGENTLY!!!!!!
Remember folks this is the drivers side front drive shaft, if in doubt it has a splined input shaft at either end.
Cheers,
Jonny
 
1 - 5 of 5 Posts
Top