GTR Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
562 Posts
Discussion Starter · #1 ·
Does anyone have the wiring diagram needed for the Intake and EXT sensors for the MFD to have them working. I have the Intake sensor and the EXT on order and as I have the Vspec model I have access to them. Just need to have both wired to have them functionable on the MFD unit. Thanks and also got my MFD working proper so weekend it is going in and also going to have the wires for the EXT and Intake run as well.

Jason.
 

·
Registered
Joined
·
1,589 Posts
MFD Pin 45 = intake, pin 46 = exhaust.

Looks like both sensors have just a ground wire and the signal wire so should be easy to do.

 

·
Registered
Joined
·
562 Posts
Discussion Starter · #3 ·
Okay so these do not need to be wired through anything else, just straight from the sensor to the MFD? Using the MFD pin 13 ground and 45 and 46 for both sensors, hmmmmm sounds too easy. Will give it a shot.
 

·
Registered
Joined
·
1,589 Posts
Certainly looks that way.

Oh and I got my pin numbers round the wrong way in the first post - its 45 for exhaust, 46 for intake.
 
1 - 5 of 5 Posts
Top